PROTEA VITAL DCF3LO-1V-270

Ostomy collection bag type:

  • Drainable and clamp closure
  • Two piece bag

Protection:

  • High capacity bar filter
  • Raincoat film between stoma and filter to prevent leakage through the filter

Comfort:

  • Flange specially designed to easily follow the contours of the peristomal skin
  • Non-woven body side comfort layer
  • Outer comfort layers with inspection window

Properties:

  • Flat flange
  • Flange opening range: 13 – 63 mm
  • Bag size: Large
  • Total height: 290 mm
  • Total width: 150 mm
  • Width of the bag opening: 65 mm
  • Ring diameter: 70 mm

Packaging: 15 pieces

  • The ostomy collection bag PROTEA VITAL DCF3LO-1V-270 consists of several layers (films or foils) that are welded along the perimeter, as follows:
  • Starting from the body side to the outside, the first component of the pouch is a connecting element, called base plate. The baseplate is made of hydrocolloid and a plastic ring and is independent from the bag itself. The baseplate has an attachment system to which the bag is attached and an opening that surrounds the stoma. It ensures the attachment of the entire pouch to the patient’s abdominal area, respectively to the perimeter area of the stoma.
  • The first layer is the interior comfort layer made of non-woven material.
  • The second layer is the bag foil of itself.
  • The third layer is the impermeable foil. It has three incisions made in the upper part to allow the relieve of gases, released by the body effluents, into a compartment from where they will be filtered and subsequently evacuated to the outside.
  • The forth layer is the outer pouch foil. This foil has a filter welded inside at the top of it. The filter has an incision made on its outer part that ensures the evacuation to the outside of the gases released by the body effluents.
  • Between the second and forth layer, the so-called collector compartment for body effluents is generated.
  • Between the third and forth layer, the so-called filter compartment, mentioned above, is generated.
  • The fifth and sixth layers are outer comfort layers, they are in direct contact with the outside, respectively with the patient’s clothing. These layers, on the one hand, obturate the content of the bag providing discretion, and on the other hand, because they have an area where they overlap, they provide a pocket (a flap) for inspection.
  • Due to the fact that the ostomy collection bag PROTEA VITAL DCF3LO-1V-270 is a bag with emptying (with discharge, open-end or drainable) it has an opening in its lower part that allows the discharge of the body effluents.
  • For opening in order to empty the bag, and then closing the PROTEA VITAL DCF3LO-1V-270 ostomy collection bag in easy, hygienic and secure conditions, it also has the following elements at its bottom:
  • Finger pocket. A reinforcement strip positioned outwards (towards the clothing) and welded at the lower end of the bag opening, on the outer pouch foil, generates the so-called finger pocket. Thus, by operating this finger pocket with the help of the fingers, it is allowed to empty the bag in hygienic and secure conditions.

Do you have a question about this product?

You can send it to us at the e-mail address office[@]protea-vital.com. Thank you!